New low temperature Children doodle toy 3D pen with 15 bags of PCL filament and LCD control temperature safe for children use
In this SKU , the pen have Blue and Pink color available, each color you can choose to add extra 15 bags PCL material
This is a new product, price is very good
|Discharging mode||Hot melt extrusion molding|
|Working voltage||5V 2A equipment|
|Spiting speed:||1-4 level adjustable|
|Product material||Plastic shell|
|LED display can directly show the information like supplies type, speed, temperature, warning，more humanized display interface|
|use matrail PCL|
|Support dual-mode for feeding, hold the “Forward” button to feed continuously and release to stop feeding, or double press the “Forward” button to feed continuously and press again to stop feeding|
|Long press “Return” button for 2 seconds to return the supplies automatically|
|Intelligent sleep，It enter into dormant state automatically if without operation for 3 minutes, the nozzle stop heating, more secure to use|
|The outer packing size||20*11.5*7.4CM|
1. This equipment is suitable for children over 8 years old and adult. It can be used by children .
2. Front near the tip and the device for high temperature danger zone, so it is forbidden to touch or use the pen point touch other items.
3. It is prohibited to insert foreign body into the entry hole.
4. The equipment is precision electronic instruments, keep it away from water and other liquids.
5. Please put it in a safe place, to prevent falling from high altitude or away for children’s touch.
1 × 3D pen
1 × Power adapter
1 × Pen cap
1 × User Manual
1 × Material PCL
1. Connect the power adapter with power source, and the other end into the 3D pen. If he Red LED lights on, the LED screen displays “PCL” , it means the equipment has entered the standby state.
2. Press “Forward” button, the red LED light change to yellow, which indicates that the equipment has entered into warm-up state. When the red LED lights changes to blue. It means the process is finished and the equipment can operate normally.
3. Insert the supplies into the “supplies introduction hole”, then press “Foward” button, supplies will be conveyed by the built-in motor of the equipment. When the glue is spit out from the integrated nozzle heating head , it means the 3D pen is installed successfully.
4. Recommended ：80-90℃. Different colors of homogeneous supplies have different melting points, please tune the temperature according to the yielding situation . (Please refer to ” temperature tuning” part for the melting point and temperature adjustment of the supplies )
5. The device will enter into sleeping mode automatically and the LED screen will display “SLEEP” when the device is not used more than 3 minutes. If you need to use it again, press “Forward” button to trigger it.
6. If you need to change supplies, please press “Return” for 2 seconds and then repeat step 4.
Heating time is influenced by preset temperature and environmental temperature.
Remember to uninstall the supplies after use.
Due to the different melting points for different color supplies, in order to improve the quality of creation, please pay attention to the following questions:
1. In low speed working mode, if you hear “crackling” sound from the nozzle end, it means the temperature is too high, press“Temperature control switch “button to turn the temperature down, the adjustment range should be 5-10℃.
2. In normal working mode, if encounter lots of bubbles, showed that the temperature is too high, press the “Temperature control switch” button to turn the temperature down, the adjustment range should be 3-8℃.
3. If the surface color of extrusion glue become dim and dark, sounds of the motor become obviously difficulty, it means the temperature is too low, use the temperature control switch button to raise the temperature, the adjustment range should be 5-10℃.
4. Normal spiting should be smooth without bubbles. (occasionally bubbles)